Search found 4 matches

by Tony From West Oz
Fri, 09 Feb 2018, 00:30
Forum: Parts & Suppliers
Topic: EV-Power - experiences?
Replies: 6
Views: 2244

Re: EV-Power - experiences?

Rod supplied the BMS for our 48V LiFePO4 stand alone battery. Works well, isolated battery when one cell voltage dropped during an extended discharge. When charge applied and BMS reset, all worked well again. I have not had any need to check on cell HV, but I am sure it will work as well as when on ...
by Tony From West Oz
Fri, 09 Feb 2018, 00:22
Forum: Technical and conversion discussion
Topic: Quad bike EV
Replies: 6
Views: 1635

Re: Quad bike EV

Thanks Richo. I have started a new thread.
Tony
by Tony From West Oz
Fri, 09 Feb 2018, 00:16
Forum: General EV Discussion
Topic: Converting petrol quad bike to EV
Replies: 11
Views: 2196

Converting petrol quad bike to EV

I have a quad bike with a dud motor. The motor and gearbox are in the same unit and it has a shaft drive to the rear axle. I would like to convert this into an EV, fitted with a 48V Lithium battery which could be connected to our 48V LiFePO4 stand-alone power system battery, to provide additional st...
by Tony From West Oz
Wed, 07 Feb 2018, 21:32
Forum: Technical and conversion discussion
Topic: Quad bike EV
Replies: 6
Views: 1635

Re: Quad bike EV

Did you proceed with this project?
What was the outcome?
I have plans for a similar project, but apart from the bike, have little to go on.