Mitsubishi EV Interest Group
Peter C in Canberra
Senior Member
Posts: 418
Joined: Sun, 27 Jul 2008, 04:05
Real Name: Peter Campbell
Location: Canberra


Post by Peter C in Canberra » Thu, 08 Jun 2017, 21:14

g4qber wrote: Correct dry air is good. Where do we get it?

To some extent, compressor air, if sent via a storage tank, is likely to be dried a bit anyway. Water vapour in the compressed air cooling in a tank will condense so the tank should have a drain. When the air is drawn off the tank it will be drier than the source air was, albeit not super dry.

In a previous life I used to open the manual drain on a compressed air tank once a week before we got an automatic drain. In our case we wanted extra clean, laboratory grade air so it went through further drying and various stages of filtration for hydrocarbons and other things. That air was then drawn off for various scientific instruments or to feed a nitrogen generator that stripped out the oxygen to feed very clean nitrogen to various instruments. For ordinary car tyres, I'd say the dryish air from an ordinary compressor/tank arrangement should be fine. Not quite good enough for a sensitive mass spectrometer, but that is not what we are doing here!
Daihatsu charade conversion 2009 + demo iMiEV 2013 + used Holden Volt 2018, on the ACT's 100% renewable by 2020 power.

User avatar
Posts: 194
Joined: Fri, 14 Nov 2014, 13:37
Real Name: Jeremy
Location: Gosford


Post by zzcoopej » Wed, 12 Jul 2017, 23:51

Has anyone used the tyre goo aerosol can that comes with the iMiEV? I have a slow leak on my ride-on mower and wonder if I can use tiny bit of the can and still have the rest for the iMiEV, or can you only use the can only once? I think the can in the PHEV is the same as the iMiEV so it should be ample even after I use a bit?
Last edited by zzcoopej on Wed, 12 Jul 2017, 13:52, edited 1 time in total.
2010 iMiEV
2015 PHEV Aspire
Battery App EvBatMon for PHEV & iMiEV iOS(iPhone,iPad)& Android

Post Reply