AEVA Forums

Hi Weber, Thanks Mate.Are you going into production with the EV MX5? May be you can give me some ideas on my VR commodore when I get round to it:) Big dreams.. Post SOLAR Inverter panel installs ..Hopes.. [Moderator note: Weber's response to the above is in the PIP-4048MS and PIP-5048MS inverters to...

Hi Coulomb, All good Installed 72.70b with thanks.No issues ..still prayed! Setting 38 now available for N earth. Not sure how setting 32 works ..? I set 32 to 10mins? Is the Post by you 24th Feb2017ad latest and easiest to understand on absorption/ BC process,setting etc ? Thanks for info on o/heat...

[Moderator note: This is partly a response to this post in the PIP-4048MS and PIP-5048MS inverters topic .] Hi Coulomb, Thanks so much for your swift reply!! I had to get back to other more menial tasks , apologies for my delay in reply. So just confirming 72.70 with no suffix to get my desired sett...

Hi Guys, Thanks so much for the new 72.4 firmware for Pb from old 52.3. Instructions work fine --I was a bit stressed.Had to make serial cable ..but thanks to paukvk was to get the pin outs for D9 and Mod Plug because I don't think I received cable with my Inverters. Anyway "Install success" with tr...

Hi Weber, OK ..thanks so much for the info http://forums.aeva.asn.au/smileys/smiley20.gif I will be an expert at pulling these PIP'S down.Two more pull downs and two re-assembles to go. By the way Paulvk and I have put two external 120mm 240Vac fans(running from 240VAC O/p) at top cooling exists wit...

Hi Coulomb, Great to have schematics! I have just done the cap mods.Replaced MFR PART#EKZN800ELL182MM40S 1800UF 80VDC 105C UCC 10,000 HR ELECT.CAPACITOR the decided best option on the PIP4048. Had some old blank pcbs I could use.Paralleled caps to get value .They all came in when measured above 3300...

I wonder how long we will wait?
Thanks Ian.

Quick answer on Nichicon is no stock ..but can make volumes. We are investigating these capacitors that this was not an O/volt issue but an ESR,temperature,(yes aging too) as they are mounted right next to heatsink. It was as load ramped up to 82A from batteries inverting to 240VAC 4KW load that cap...

Hi Weber,Thanks again for that.. Will advise on Nichicon caps either way-
Will get to parallel mode yet.

Hi Weber , Thanks for that and first message ...Yep will do .Plan to do all that.Concur on mosphets and overall view. We will need about 32 capacitors for all units.We were thinking about Nichicon for caps but have to check specs & bulk order? You guys using earth straps on wrists? Thanks again..no ...

Hi All, I'm new to the forum.Great to be able to contribute. Paukvk and I purchased eight PIP-4048WM VERSIONS(2015). One(mine) has been on line for about 2 years just out of warranty.Paulvk for about same time. HAs been running well until last week or so when loaded up to 82A through batt/solar mode...